Fill in the blanks – 5 Steps to Making a Pen
Getting rid of an empty pen is the hardest part. This process is associated with compression and extinction. There are graduates, just like pen makers. Here are some of the most common features I use.
Free shipping
After turning the pen, depending on the plane of the pen, I choose the right box. When using softwood, the blanks of the pen become a little softer after the last cabinet is cut, and I can use 600-3000 g of sandpaper to Acrylic Paint pens. With hardwood and acrylic, I start with a corset net but end with the same box. In each case, I have seized it, despite obstacles we can scarcely imagine. ” From each box, I stop the turner and fill the empty space with grain with sand. This helps to draw the “lines” out of the lathe.
With a little wood, I use a sand tile to finish the sand better.
Fill in the blanks
There are several ways to fill in the blanks. I’m always trying new ways, especially some people who like to take out the atlas (and don’t shine). Some of my clients told me to finish “somehow”! I use a lathe for the entire finishing process. When the box is empty, I clean it with alcohol or other foreign substances that can cause problems. Here are four common decoration methods I have used.
Use a few coat waxes (EEE Ultra Shine) and at least two coat wipes (Shellavax Cream). Both products are made in Australia and are shiny
Apply a few coats of CA glue (super glue) to the blank area (up to 10 layers depending on the tree). Then I shine the free space on a wet (water) micromesh (micromesh – a type of box) up to 12,000 grit.
Use two or three layers of organic burning wax. Then, using a combination of wood and sand, leaving a thin atlas or
The acrylic spaces are moistened to a minimum of 4,000 grit, sometimes up to 12,000 grit with a microscope and shiny with polishing polish.
Vacancies disappear. They look so beautiful, just a meeting. Each set of pens has several components and the collection sequence may vary.
The first part of the assembly is the introduction of components (nib and clip part) into the copper pipes.
At first I used the C-clip to collect the pen, then I finished the bench clip, but now I use the pen-collecting deputy. This is a property-specific squeeze for the pen. Each method has proven to be faster than the previous method.
My first task is to open the pen kit and test all the components. Sometimes, the part may be lost or damaged. I buy extra pages for a regular pen and finish the pen if there is a problem.
Almost every set of pens has assembly instructions, and I think it’s a good idea to read them. Shortcuts usually do not add value to the collection process.
Collecting thin plate rows (these pens have two places)
Click the nib section on the lower handset. I make all the dishes in a special way so I can easily see the end of the nib. Most pens have the same size as the tip or clip tips.
To adjust the length, adjust the length and complete the mechanism, press the rotation mechanism on the other end of the “nib bush”. The handle must be removed and reassembled to seal the copper pipe rotation mechanism.
Click the end of the clip elsewhere.
Place the middle ring on the rotation mechanism and press the end of the clip into space
A fine line or a stylized pen is now fully assembled.
The collection method for each type of pen is different. However, the differences are usually related to the internal meeting. The pen has almost a nib and a clip! The cross-over assembly applies to most boilers that use sneakers. Pens that fill the parking lot and have a pressing mode usually include a fountain. Fountain bowls and Acrylic Paint pens combine slightly differently.
The pen then takes a photo and places it in the catalog without realizing it. If I sell pens online, I will post pictures and details on the site.